Testing unbranded mini PRVs

See also:

IK valves and PRVs
Fitting 4.8psi PRVs to a Seawave

I fitted over-rated 4.8psi Ceredi PRVs to my Seawave’s side tubes a few years back. I like the idea of not having to worry about the boat getting hot in the sun (and exploding), just as much as gaining some extra rigidity by fitting PRVs rated a little higher than recommended side tube pressures.

I bought a pair of unbranded Chinese PRVs off eBay (<£9 posted – about 30% of Ceredi/Leafield prices) to consider for my next IK. Some sold on eBay don’t even mention the purge pressure! These ones did: 4psi or 0.27bar, just a bit over the 0.25 of the boat I have in mind.

Out of the bag, the quality of the molding looked no worse than a Ceredi. I was a bit surprised they’re smaller than usual PRVs, (the listing gave these dimensions), but what does it matter as long as they work.
I worked out a way of testing them by removing the backing ‘nut’ and screwing the ‘male’ PRV housing onto a rubber motorcycle throttle grip. The other end of the grip I jubileed to the barrel pump nozzle.
Pumping the pump, the pressure built up and PRV ‘burped’ suddenly at an indicated 0.4 bar. But as my manometer needle zeros at 0.1 bar and not zero, we can probably subtract that 0.1 and call that 0.3 bar which is 4.34psi. Close enough to 4psi. Now I can fit these PRVs with confidence.

The hole which must be cut in the boat to fit this valve is 24mm ø, but to get the back nut inside the hull you’ll need to go in via the larger inflation valve aperture. So cut the PRV hole close to the inflation valve. Once loosely screwed together, the knurled outer housing can be tightened with some wrench or another.